Filter Results By:
Products
Applications
Manufacturers
- Taylor Dynamometer, Inc.
product
Water Brake Chassis Dynamometers
Chassis water brake dynos (also known as hydraulic dynamometers) can be operated continuously to resolve overheating, fuel mileage and drivetrain issues. Taylor’s eight models accommodating 50 to 1,100 hp at 40 mph enable testing of single-axle diesel pickup trucks, RVs and buses up through the largest tandem-axle on-highway trucks and buses. Tap into our deep product and applications knowledge to help you choose and make the most of the right water brake system for current and future needs.
-
product
IPX3 IPX4 Rain Test System
CX-RIP3/4
Shenzhen Chuangxin Instruments Co., Ltd.
For checking the protection against water with spray nozzle of 0,4 mm bore are used to prove the degrees of protection for the second characteristic numerals 3 and 4 “Protection against Spraying Water” resp. “Protection against splashing Water”.
-
product
UL Rain Spray Test Device With Nozzle
CX-UL56
Shenzhen Chuangxin Instruments Co., Ltd.
UL rain spray test device with nozzle Size:500*800*2000mm((adjustable height 1000~2000mm)Nozzle water column intersection from the ground height 0-1400mm adjustable
-
product
IEC60529 IPX3 IPX4 Brass Water Spray Nozzle For Hand Sprayer
CX-IPX34
Shenzhen Chuangxin Instruments Co., Ltd.
The IPX3-4 Spray Nozzle is a hand-held test device to verify protection against spraying and splashing water.
-
product
Rain Spray Test Environmental Chamber
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell’s rain spray test environmental chamber is also known as rain spray test chamber, it is used to test the water resistance for electronic and electrical products, such as solar lights, garden lights, buried lights, tunnel lights, car lights, fountain lights, the display…etc. It can also provide references for product design and quality control.
-
product
IP66 Rated Mass Flow Controllers
I-Series
I-Series Thermal Mass Flow Controllers are designed specifically for mass flow controller applications in harsh environments to protect against water and dust. The IP66-rated enclosure for I-Series Mass Flow Controllers protect it from direct water spray as well as dusty environments.
-
product
Hydrogen Leak Tester
T8999
T8999 is a tool designed to meet the increasing need for easy and clean identification of the position of the leak on a piece being tested, therefore eliminating the need for methods such as water tank immersion or use of leak detecting sprays, which are harmful for the pieces which could develop rust or pieces that are difficult to accurately clean.
-
product
IPX9K Rain Spray Testing Chamber / Rain Resistant Test Machine
CX-IP9K
Shenzhen Chuangxin Instruments Co., Ltd.
Water Spray Test Equipment is used to test the water resistance; which is mainly for electronic and electrical products. It can also provide references for product design and quality control.
-
product
IEC60529 IPX3/4 Oscillating Tube Spray Water Test Chamber
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60529 IPX3/4 oscillating tube spray water test chamberWorkshop:60*60*60 cm / 100*100*100 cm
-
product
Water Spray Tester
K10640
Chongqing Kailian Yongrun Industrial Co.,Ltd.
To evaluate the ability of a lubricating grease to adhere to a metal surface when subjected to direct water spray under controlled conditions;Conforms to SH/T0643, ASTM D4094
-
product
Moisture Test Chamber
The chamber features a self-contained water recirculation system that eliminates the cost and inconvenience of plumbing in a facility water supply. Water is injected into the test enclosure through specifically-sized nozzles. Flow meters with adjustment valves supply the spray at specified flow parameters. A rotating test platform can be incorporated to promote even moisture distribution over the surface of the products under test.
-
product
IP X5, X6 - Walk-In Rain Test Chamber
WEIBER designs and manufactures standard as well as customized water spray test chamber for evaluating various automotive, electrical and electronics items under water, rain or shower conditions. The chamber interrogates the performance of parts when subjected to water droplets.The system is based on the IP X5, X6 specification requirements, and can also accomplish individual automaker’s tests, as well as electrical-enclosure tests.Our system uses multiple control solenoids to vary the water's spray volume/pressure. A holding tank prepares the water to the desired temperature, if required. A pump ensures the water is delivered in the proper pressure range.
-
product
IEC60529 Ipx6 Water Spray Nozzle
CX-IPX5-6
Shenzhen Chuangxin Instruments Co., Ltd.
IPX5/IPX6 Jet Nozzle Test consists of a jet handle that is equipped with a pressure gauge and an easy-to-adjust flow valve.
-
product
Environmental Simulation Testing
Innovative Testing Solutions, Inc.
We have multiple chamber capabilities of simulation most environmental conditions. Our chamber range in capacity from 1 ft3 to 64 ft3 volume. Specialty chambers include air-to-air thermal shock, inert gas injection oven, high/low pressure water spray and direct-injection LN2 chambers.
-
product
IP Waterproof Test Equipment
Shenzhen Bonad Instrument Co., Ltd.
BONAD’s IP waterproof test equipment is divided into nine common waterproof levels according to international and national standards, namely IPX1, IPX2, IPX3, IPX4, IPX5, IPX6, IPX7, IPX8 and IPX9. In addition, there are many different comprehensive rain test chambers, whether it is the common nine instruments or customized spray chambers, charging pile water spray tests or energy storage cabinet spray tests. For more information, please contact us, BONAD will provide you with professional technical advice and high-quality testing equipment.
-
product
Walk in chamber for Complex Salt Spray Test (Temperature controllable)
Guangdong Bell Experiment Equipment Co.,Ltd
Walk in chamber for Complex Salt Spray Test Relevant standards requirement1. Test Object: battery pack andsystem.2. Refer GB/T4 part 5.5.2 test method, test according to GT/T2423.17 test conditions.3. The salt solution was made up with sodium chloride (chemically pure and analytically pure) and distilled or deionized water，Its concentration is (5 + 1)% (mass fraction).4. (35 ± 2) ℃, the measured pH value is between 6.5-7.2.5. Placed the test objects in the salt spray chamber for cycling test. Each cycling duration for 24h. Spray salt solution to the test object for 8 hours under the temperature of (35± 2) ℃ , remain for 16 hours. Between the forth and the fifth hour in one cycles should be according to test requirement in GB/T 28046.1-2011, test mode with 3.2.6. Total 6 cycles testing.7. Salt spray test is not necessary for the test objects being installed in passenger, luggage or cargo compartments.
-
product
IEC60529 IPX34 Hand Held Spray Nozzle
IPX34
Shenzhen Chuangxin Instruments Co., Ltd.
The Spray Tester IPX 3/4 is a hand-held test device to verify protection against spraying and splashing water. The water pressure can be adjusted using the flow control knob on the device to give the required flow rate.
-
product
Venturi Sprays
1912
Parker Conflow’s Code 1912 is a Venturi spray nozzle for the purpose of dust suppression on a cutting drum in mining that maximises efficiency, whilst minimising the amount of water it uses.
-
product
IEC60529 Ipx56 Water Spray Test Device
IPX56A
Shenzhen Chuangxin Instruments Co., Ltd.
The ipx5/6 rain testing machine is designed according to IEC60529 standard.
-
product
Salt Water Spray Test Chamber
CX-H60L
Shenzhen Chuangxin Instruments Co., Ltd.
The salt water Spray Tester is used to create and maintain the salt spray (fog) test environment, and test the anti-corrosion quality of the materials surfaces, and is suitable for researching materials, light industry, electronic, instrumentation and other industries etc.
-
product
IPX3/4 Swing Pipe Rain/ Water Spray Chamber
Shenzhen Chuangxin Instruments Co., Ltd.
Ipx3/4 Swing Pipe Rain/ Water Spray Chamber 1. Item name: Ipx3/4 Swing Pipe Rain/ Water Spray Climatic Chamber
-
product
IPX5 IPX6 Water Spray Test Device
CX-IPX56B
Shenzhen Chuangxin Instruments Co., Ltd.
Drop rain rain chamber Uses: This equipment is main to test the physical and other related properties of the products in the environment of simulated rain, such as electronic and electrical products, lamps, electrical cabinets, electrical components, automobiles, motorcycles and their parts and components. After the test, through the test result to determine
-
product
Automatic Defluxing System
Trident
Trident’s optimized spray technology delivers precisely directed streams of cleaning solution and ultra-pure deionized water across assemblies, effectively reaching under low-clearance components. Our proprietary focus wash technology minimizes shadowing, enhances coverage, and consistently exceeds industry cleanliness standards while a dual heating system (radiant and convection) ensures complete and efficient drying.
-
product
V Sprays
1293
A knife edge spray form suitable for dust suppression applications in mining and quarrying which maximises dust capture and avoids over-wetting
-
product
Salt Spray Chambers
Weice Testing Instrument Co.,Ltd.
The WTS series of salt spray chambers are manufactured and designed to meet the high quality requirements and standards, such as ISO, JIS, DIN, ASTM, IEC, GB and SAE. They are used to test the resistance capabilities of materials eroded by brine, these materials may be used in Electrical Appliances, Electrical Wire, Accessories, Luminaires etc.
-
-
product
Salt Spray Test Machine
YWX/Q-010
The Salt Spray Test Machine/Chamber is applicable to the salt spray corrosive test for the protection layer of components, parts, electronic and electrical parts and metal materials and industrial products. • The Salt Spray Test Machine is made of transparent materials so that the operator can see the tested sample in it and the spraying situation of the tested sample. • A waterproof structure is adopted between the chamber cover and chamber body, thus there is no salt spray overflow. • Adopts the tower spraying system and equipped with the salt solution filter system and non-crystal nozzle so as to realize even salt spray distribution and freely adjustable settlement. • It meets the following standards: IEC60068-2-11 (GB/T2423.17), GB/T10125, ISO9227, ASTM-B117, GB/T2423-18, IEC 60068-2-52, ASTM-B368, MIL-STD-202, EIA-364-26, ASTM-B117, GJB150, DIN50021-75, ISO3768, 3769, 3770; CNS 3627, 3885, 4159, 7669 etc.
-
product
Hexagon Head Drum Sprays
850
A Stainless Steel Socket Head Drum Sprays provide a wide range of spray forms for pick flushing on cutting drums.
-
product
Salt Spray Chambers
Specialized equipment used to simulate and measure the effects of salt spray or salt fog test on materials and coatings.
-
product
Water Meters
Shenzhen Star Instrument Co., Ltd.
IC cold/hot water meter manages perches and consumption by using a contact IC card as data medium.
-
product
Water Accumulation Unit
WXU
An integrated unit that integrates the flow sensor and valve of the circulation circuit of the cooling water.The complicated piping design around water and the number of man-hours for piping work are greatly reduced, and the footprint is reduced by 80% to save space in the system.
