Filter Results By:
Products
Applications
Manufacturers
-
product
Quantum Cascade Laser Sensors
QCL sensors use mid-infrared semiconductor laser sources, either intraband Quantum Cascade Lasers or Interband Cascade Lasers to enable high precision, high accuracy, and selective detection of trace gases such as greenhouse gases and chemical agents with application to a variety of commercial, industrial, defense and environmental problems.
-
product
Scientific SWIR Camera
1280SCICAM
Princeton Infrared Technologies, Inc.
This non-ITAR reduced weight (3000g) lattice matched, InGaAs scientific SWIR camera allows for high resolution SWIR imaging at 1280x1024 with high frame rates >93 frames per second (fps) at full frame size. This small pitch array,12 μm, combined with the high quantum efficiency of lattice matched InGaAs enables impressive imaging in the SWIR and visible spectral bands. The SWIR camera has the capability of four temperature setpoints, -20°C (no cooling), 0°C (fan cooling), -40°C, or -60°C (water cooled), using a 4 stage TEC integrated in a vacuum-sealed package. This advance digital array (PIRT1280A1-12) on board is a product of Princeton Infrared's decades of experience in InGaAs processing.
-
product
High-Performance, Low-Noise Cameras
PIXIS
Teledyne Princeton Instruments
The PIXIS offers the broadest wavelength coverage, from ~120 – 1100 nm, for the widest variety of applications.With >95% quantum efficiency (QE) with selected CCDS, high QE in UV with UV enhanced CCD and enhanced sensitivity and reduced etaloning with eXcelon™ technology.
-
product
R&D Solutions From Teledyne LeCroy Quantum Data
Teledyne LeCroy offers a wide variety of products for engineers in the R&D lab. R&D testing entails functional testing for source and sink devices as well as interoperability testing for diagnosing problems between A/V devices. Solutions for silicon chip manufactures are available for both source and sink devices. Quantum Data solutions are available for testing HDMI, MHL, DisplayPort, HDBaseT and 3G-SDI products.
-
product
Multi-Protocol Analyzer / Generator
780E
The Quantum Data 780E Multi-Protocol Analyzer / Generator is a handheld digital video generator and analyzer that enables you to run tests on various digital video devices and network distribution devices on site or in the R&D lab. The 780E instrument provides a 7 inch color touch screen for operation and for viewing status of outgoing and incoming video and audio. The 780E is equipped with DisplayPort, HDMI and HDBaseT interfaces. Each digital interface is supported by both an output port and an input port to allow testing of digital video sources, displays, audio devices and distribution devices. Testing hybrid converter devices supporting DisplayPort, HDMI, HDBaseT distribution networks is a key application of the 780E as well.
-
product
Ultrasonic Testing
Pundit 250 Array
The Pundit 250 Array brings a quantum leap in the ultrasonic pulse echo testing. A number of unique innovations make the Ultrasonic multi-channel instrument the best and fastest solution for thickness measurements, detecting defects and localizing objects which cannot be easily detected by any other technology. This includes the assessment of thick concrete elements such as tunnel linings as well as pipes and tendon ducts beyond the rebar layer.
-
product
Superconducting QUantum Interference Device (SQUID) Magnetometer
Quantum Design MPMS®3
Quantum Design's MPMS 3 represents the culmination of 40 years of development and design in the world of SQUID Magnetometry. Providing users with the sensitivity of a SQUID (Superconducting QUantum Interference Device) magnetometer and the choice of multiple measurement modes, the MPMS 3 offers new levels of performance in magnetic research while including those aspects of past Quantum Design SQUID magnetometers that customers have grown to appreciate and depend on.
-
product
Absolute Quantum Gravimeter
The Absolute Quantum Gravimeter is the only quantum gravity sensor available on the market place. Thanks to its disruptive technology, this instrument offers unique features:*Absolute gravity measurement at the µGal level.*Automated Continuous Data Acquisition for several months. No long-term drift.*Excellent immunity to ground vibrations thanks to an active compensation system (no mechanical isolation).*Easy and quick operation : the AQG is ready to measure within 1h (no laser alignment nor mechanical assembling, no preliminary pumping, no superspring). User-friendly software requiring no knowledge in quantum physics.*Compact and transportable sensor.*Low maintenance constraints (in particular, no moving parts in our vacuum chamber).*Station to station repeatability of the absolute measurement within a few μGal.
-
product
Quantum Computing Control System
In 2018, Zurich Instruments introduced the first commercial Quantum Computing Control System (QCCS), designed to control more than 100 superconducting and spin qubits. Each component of the QCCS is conceived to play a specific role in qubit control, readout and feedback, and operates in a fully synchronized manner with the other parts of the system. LabOne®, the Zurich Instruments control software, enables fast access to qubit data and facilitates the integration into higher-level software frameworks.
-
product
Complete Testing Solutions
System includes a lamp and monochromator for a tunable light source, which is coupled to a high sensitivity source meter with measurement software. This user-friendly system is the most powerful Spectral Response system currently on the market, but its true power is the ease of upgrading from the base PTS-1 to the more powerful PTS-2-QE (Quantum Efficiency) or PTS-3-CPM (Constant Photocurrent Method). Designed for researchers who have limited budgets but want to start work immediately, this allows the ability to do baseline studies until additional funding for the full QE or CPM system becomes available.
-
product
Horticulture Meters
Cultivate and preserve healthy plants using the Solarmeter® GrowMeters, and Solar Light’s Digital and/ or Analog Quantum Light (PAR) calibrated sensors. Our point-and-click NIST-traceable meters are used to monitor lamp intensity and aging for horticultural applications. By measuring the intensity of luminaires and grow lights, these meters will ensure lamps are performing as needed to produce healthy valuable crops.
-
product
Back-Illuminated Scientific CMOS Camera
KURO®
Teledyne Princeton Instruments
The KURO® is the first back-illuminated scientific CMOS camera. With high sensitivity and fast frame rates the KURO is optimal for applications such as hyperspectral imaging, astronomy, cold-atom imaging, quantum imaging, fluorescence spectroscopy, and high-speed spectroscopy
-
product
Quantum Efficiency Measurement Systems
Newest generation of quantum efficiency (yield) measurement tool, which allows the user to determine QE of powders, liquids, solids and films. An optically optimized geometry using an integration hemisphere and low stray light array spectrometer enables world class measurements and new applications.
-
product
Space Payloads
With our expertise in both space and quantum technology we are exploring space based quantum instruments. CASPA is Teledyne e2v’s satellite platform for developing and demonstrating quantum scientific sensors and precision atomic timing in space.
-
product
Fully In-Vacuum, Direct Detection X-Ray Cameras
PI-MTE3
Teledyne Princeton Instruments
Large format, fully in-vacuum CCD cameras, offering flexible detector orientation and proximity to sample through sensor and camera design. With back-illumination technology, the PI-MTE3 delivers >95% peak quantum efficiency over the ~10 eV to 30 keV energy range. Efficient liquid cooling offers low dark current, facilitating long exposure times, with the four-port readout architecture offering 7-10x higher frame rates than previous generation two-port cameras.
-
product
AC Quantum Voltmeter
are based on a programmable Josephson voltage standard chip and are used for high-precision voltage measurements in the range from dc and ac to kHz frequencies.
-
product
9GS/s 16Bit 8GS Mem 12CH 8 Markers RF AWG Desktop
P94812D
The desktop version of the Proteus arbitrary waveform generator series offers up to 12 channels in a 4U, half 19” dedicated chassis. The compact form size and small footprint save valuable bench space. So for synchronized, phase coherent, multi-channel applications such as quantum physics and radar applications the Proteus arbitrary waveform transceiver is an ideal, space efficient, and cost effective solution.
-
product
Front Side Illuminated Sensor with Pixel Size of 5.3µm with NIR Spectrum Sensitivity
Ruby Family
The EV76C660 and EV76C661 are members of Teledyne e2v’s Ruby family of CMOS imaging sensors. These breakthrough devices provide sensitivity and performance beyond that considered possible on a front side illuminated sensor with a pixel size of 5.3µm, Quantum Efficiency (QE) of over 80% and excellent sensitivity and performance in the near-infrared (NIR) spectrum (>50% at 850nm). This significantly reduces system illumination costs, or enables very low-light imaging in outdoor camera applications.
-
product
DPSS Lasers
Quantum Composers laser division features three series series of diode pumped, solid state, Nd:YAG lasers. The Jewel, MicroJewel and the MIR Mid-Infrared DPSS Lasers range in energy output from 1mJ to 15mJ . These compact and rugged lasers are commonly used for LIDAR, PIV, LIF, OPO, TFT-LCD repair, ablation and spectroscopy applications.
-
product
PAR Quantum Radiometric Probe
LP471PAR02
Quantum-radiometric probe for measuring the PHOTONS FLOW in the chlorophyll field PAR (photosynthetically Active Radiation 400…700 nm), μmol m-²s-¹ measure, opaline quartz diffuser for cosine correction.
-
product
Phase Locked Laser System
SolsTiS-Phase Locked
The phase locked SolsTiS system is primarily designed for use in atom interferometry and quantum computing where Raman transitions are commonly used, although we can tailor the setup to other applications. The system provides extremely low phase noise and high output powers. Full control over the system is provided through our easy to use Ice Bloc user interface.
-
product
Physical Property Measurement System
PPMS
The Quantum Design PPMS represents a unique concept in laboratory equipment: an open architecture, variable temperature-field system, designed to perform a variety of automated measurements. Available measurement options include all required hardware and electronics to immediately begin collecting publication-quality data, while the system is also easily adapted to custom user experiments. Sample environment controls include fields up to ±16 T and a temperature range of 1.9 - 400 K. The expandable design enables combining many features in one instrument to make the PPMS the most versatile system of its kind.
-
product
Spherical Underwater Quantum Sensor
LI-193
The LI-193 Spherical Quantum Sensor measures PAR in air or underwater from all directions at depths up to 350 meters. This sensor is useful for studies of phytoplankton, which uses radiation from all directions. The measurement is referred to as Photosynthetic Photon Flux Fluence Rate (PPFFR) or Quantum Scalar Irradiance.
-
product
Spectral Response SystemsQuantum Efficiency SystemsIPCE Measurement Systems
QE system provides electronics and software designed for fully automated measurement of external quantum efficiency of solar cells. All systems include probes and a fixed plate sample stage for samples up to 150 mm x 150 mm. The main system components include: custom designed software, measurement electronics, and computer system (Windows 8 operating system). The measurement involves focusing monochromatic light to a spot on the device under test, then accurately measuring the photon flux and current from the test cell. The system utilizes a dual beam configuration with lock-in detection, providing an absolute accuracy of ±3%. The QE system uses a grating monochrometer with silicon/InGaAs/Ge detectors. The system includes automatic order sorting filters and two light sources for monochromatic illumination (a Xenon- arc lamp and a halogen lamp). A single lock-in amplifier is used to measure both the reference detector and test device. The main system comes with all the hardware needed to measure quantum efficiency, a fixed plate sample stage and probes.
-
product
EQE/Photon-Electron Conversion Testing
Enlitech offers different solutions for incident photon-electron conversion testing systems. The available systems include IPCE, PV External quantum efficiency (PV-EQE), Internal Quantum Efficiency, Spectral Response (SR), Highly-sensitive EL-EQE. There are over 1,000 SCI papers cited Enlitech‘s systems to provide reliable experimental data for significant scientific publication. The Highest PV-EQE sensitivity and EL-EQE both reach 10-5 % (7 orders). They can be utilized to PV conversion efficiency, HJT/ PERC/TOP-CON current-loss analysis, Organic PV charge-transfer-state and Perovskite PV trap state measuring, and Organic PV and Perovskite PV Voc loss analysis.
-
product
Chamber/Pyroelectric Task
Radiant's Chamber/Pyroelectric Task sets the sample to a series of temperatures by performingGPIB control of an external thermal device. At each temperature it captures the sample’s polarization response and/or small-signalcapacitance. These are combined to calculate the pyroelectric coefficient. The Pyroelectric Task is to be used with a Radiant Test System and a Linkam Stage (-196C to 600C), Thermal Chambers, Hot Chucks, or a Furnace to automatically measure the Pulse Polarization response and Small Signal Capacitance of a Pyroelectric material that is being heated and/or cooled. Radiant's Pyroelectric measurement Task can be added to Vision at additional cost. This measurement suite fully characterizes the pyroelectric charge (polarization) response of the sample under test. The Pyroelectric Task suite controls various thermal controllers such as Quantum Design, Lake Shore, Delta Design, and many others. Detailed Listing of Thermal Controllers Registered in Vision. The Chamber/Pyroelectric Task is quoted upon request.
-
product
Line Scan Camera
Linea
Introducing Linea, a CMOS line scan camera that can help you improve your imaging and lower your costs. Linea starts with an advanced CMOS sensor with high quantum efficiency and low noise for better images. Linea is also packed with advanced features to make your machine vision job almost effortless.
-
product
Quantum Photonics
designed for the development of Quantum Light Source (QLS) related applications. Contact Optilab for more information.
-
product
Underwater Quantum Sensor
LI-192
The LI-192 Underwater Quantum Sensor measures PAR from all angles in one hemisphere. The LI-192 works in air or underwater at depths up to 560 meters. The measurements are cosine corrected and typically expressed as Photosynthetic Photon Flux Density (PPFD). For simultaneous measurements of downwelling and upwelling PAR, two sensors can be mounted on the 2009S Lowering Frame.
-
product
Photonics
Exail empowers photonics engineers all around the world with high-performance, innovative and reliable optical solutions that have proven their relevance for laser, quantum, sensing, or space applications.
