Filter Results By:
Products
Applications
Manufacturers
- Pickering Interfaces Inc.
product
PXI/PXIe Battery Simulator Module, 2-Channel, 1 kV Isolation
43-752A-103
Targeting EV, automotive, aerospace, energy storage and electric aircraft applications, the new battery simulator modules occupy a single PXI slot. These 2-channel battery simulators are capable of supplying up to 7 V and 300 mA per channel. The channels are fully isolated from ground and from each other, allowing series connection to simulate batteries in a stacked architecture.
-
product
EMS Energy Metering System
The EMS2005 (Energy Metering System) device series is used for determining the energy quantity in raw biogas, natural gas, or liquefied petroleum gas.
-
product
RE Family SOTB™ Process-Based Energy Harvesting Embedded Controllers
The RE Family based on Renesas' innovative SOTB™ process technology realizes ultra-low current consumption in both active and standby mode and fast operation at low operation voltage, which is impossible to achieve with a conventional bulk transistor. The energy harvesting controller and 32-bit CPU also enable the development of intelligent and battery maintenance-free energy harvesting IoT devices.
-
product
Fully Automatic Close Link Three Phase Energy Meter Test Bench
SY 8320
Hong Kong Songyang Industrial Ltd.
Suitable design, good figure. The frame for meters and the body frame are fully made by special aluminum alloy. The table board is composed of fireproofing and heat-proof fiber materials. The whole device is in soft color and good figure.
-
product
Run-Time Error Analyzer
Astrée
AbsInt Angewandte Informatik GmbH
Astre analyzes structured C programs with complex memory usages, but without recursion or dynamic memory allocation. This targets embedded applications as found in earth transportation, nuclear energy, medical instrumentation, aeronautics and space flight, in particular synchronous control/command such as electric flight control.
-
product
Resonance Circuit for GIS Testing
CP RC
For HV testing OMICRON’s CPC 100 + CP RC are directly connected to the voltage transformer of the GIS, forming a resonance circuit. This reinforced “Power VT” is an integrated part of the GIS. So the need for draining and refilling any SF6 gas is eliminated. Acting as both the measuring and controlling device, the CPC 100 injects the required energy.
-
product
Wind Power Solution
NXA GAMESA
The NXA GAMESA is custom-made with firmware and fixtures designed specifically for Gamesa turbines: G80x, G90x, G114, G126, G132, G145. These precisely designed fixtures make generator-to-gearbox alignment easy inside any nacelle – safeguarding reliability and optimizing the energy efficiency of the wind turbine.
-
product
DC Electronic Load Modules For The N6700 Power System
Test devices that store or convert energy by adding a DC electronic load to your Keysight N6700 Series power supply. The Keysight N6790 Series electronic load modules can perform a static or dynamic test and are available in two sizes: single-wide 100 W and double-wide 200 W modules.
-
product
Power Supplies
ZPG-500B
80Plus Gold Certified provides typical 87% efficiency at 50% of max load. The ZPG series can give you the power you need at higher efficiency, which means you can use the same power with less energy. Built in QUAD 8-pin PCI-Express graphic card connector offering further upgradability.
-
product
Moisture Analyzers & Meters
GAOTek provides a wide range of superior quality, budget friendly, and precise moisture analyzers for sale in the United States, Canada and globally. This device determines moisture content in samples by evaluating the weight loss produced after the sample is subjected to a drying process using infrared energy. The original sample is first weighted, then the remaining moisture content is evaluated on the weight loss in the sample. GAOTek offers a collection of accurate moisture analyzers of the highest quality to suit your needs.
-
product
Laser Applications
Quantum Composers offers a diverse family of lasers, laser systems, and modules, including DPSS, Nd: YAG, and pulsed lasers. Our MiniJewel and MicroJewel lasers are now available in 2 different energy options to allow customers to tailor the laser to their specific applications.
-
product
Power Supplies
ZX - SERIES
Coolmax ZX series offer 80 PLUS levels of energy efficiency, massive 12V single rail output gave you the power you needs and super quiet 140mm ball bearing fan create a proper airflow inside the case. 6+2 PCI-E connector is suitable for most demanding SLI or CrossFire systems.
-
product
High Voltage Capacitor Batteries
Lifasa - International Capacitors, SA
There are a series of elements and materials, just like in the BT equipment, for their operation in AT and that must accompany our AT capacitors for the proper functioning of these and for our installation / network, as well as the rest of equipment that compose it and that are in operation in parallel to the capacitor / s that we want to put into service for the correction of the power factor (compensation of the consumption of reactive energy).
-
product
Capacitors - Power - Heavy Current (ESTA)
Vishay ESTA is one of the few manufacturers to offer a complete range of power capacitors. These cost-effective devices for harmonic control, energy savings, and voltage stabilization are highly reliable and environmentally safe, and can be used under the most rugged conditions. Vishay ESTA power capacitors address a wide range of energy-generation applications. Their “green” applications include energy generation in on- and off-shore wind turbines and solar power plants.
-
product
Power Electronics Test Solutions
Chroma Power Electronics Test Solutions not only apply in the industries of Information Technology, Communication, Aerospace and National Defense, but also in energy efficient products such as Hybrid Automobiles, LED luminance devices, solar and fuel cells that are developed aggressively under the pressure of natural resource constraints. Chroma has a wide variety of instrumentation including AC Power Sources, DC Power Supplies, DC Electronic Loads, AC Electronic Loads, Digital Power Meters, and Automatic Test Systems that are ideal for power input/output terminal tests and dynamic simulation.
-
product
Magnetizer
X-Serie
MAGNET-PHYSIK Dr. Steingroever GmbH
The X-series pulse magnetizers are designed in control cabinet construction. They offer a full range of functions and can magnetize up to 500,000 Ws at an energy of 8,500 Ws!
-
product
Scanning Auger Nanoprobe
PHI 710
The PHI 710 Scanning Auger Nanoprobe is a unique, high performance Auger Electron Spectroscopy AES instrument that provides elemental and chemical state information from sample surfaces and nano-scale features, thin films, and interfaces. Designed as a high performance Auger, the PHI 710 provides the superior Auger imaging performance, spatial resolution, sensitivity, and the spectral energy resolution needed to address your most demanding AES applications.
-
product
Eddy Covariance Systems
LI-COR eddy covariance systems measure the exchange of CO2, H2O, CH4 , and energy between the earth's surface and the atmosphere, empowering researchers to advance scientific understanding of climate and ecosystem dynamics.
-
product
Reactive Energy Regulator
Master Control Var AT
Lifasa - International Capacitors, SA
Master control Var is a regulator that facilitates an excellent preventive maintenance by means of the programming of alarms and options to check the condition of the capacitors, offering maximum supervision and safety of the reactive compensation equipment .
-
product
Soil Heat Flux Sensors
Soil heat flux sensors may consist of several thermocouples whose measurements are averaged, a single thermopile, or a single thermopile with a film heater. These sensors measure the rate of energy transferred through a surface. Data regarding the amount of energy stored in soil as a function of time is used in energy-balance and Bowen-ratio flux systems.
-
product
Chassis Dynamometers
VULCAN Series
The high-precision chassis dynamometer VULCAN series is suitable for testing Light-Duty-Vehicles (LDV), Medium-Duty-Vehicles (MDV), Heavy-Duty-Vehicles (HDV) as well as 2-3 wheelers and ATVs. Available as either a two-wheel or a four-wheel drive set-up, HORIBA chassis dynamometers are suitable for electrified mobility with an improved energy efficiency of up to 97% efficiency. Equipped with the synchronous motor technology in each individual roller, they also cover technical requirements in high-performance ranges and allow a significantly better torque distribution when it comes to electrified vehicles.
-
product
Integrated Two-Stage Current Sensors
If ultra-low noise performance is required, our integrated two stage devices are the number one choice. With input inductances from 24 nH to 1.8 µH and a flux-noise level as low as 0.8 µPhi0/sqrt(Hz) an energy resolution of about 45 h is attained. The devices consist of a 16 SQUID series array as amplifier stage and a single front-end SQUID.
-
product
*Power/Position/Size Thermal Sensors
BeamTrack
Thermal sensors that measure laser power and single shot energy like standard thermal sensors but in addition measure laser beam position and laser size. This position sensing detector measures laser beam position to 0.1mm accuracy and laser size measurement of a Gaussian beam to +/-5% accuracy. Measuring laser position is important for laser alignment where the laser position sensor can provide feedback to the laser position control.
-
product
DC Alignment
SEP/SIP
There are analog phase control type DC power supply type and digital control type inverter energy saving type. We provide the most suitable equipment according to the current capacity and cycle time.If the "start command" is executed from the existing molding equipment, each mode of "alignment-pause-demagnetization" is continuously operated by the program inside the instrument. It is also possible to share an emergency stop signal and output an output current abnormality signal.
-
product
Energy Management Solutions
Panasonic Industrial Devices Sales Company of America
Panasonic Eco Series of Energy Consumption Visualization Components offers a wide array of products for both energy saving and power surveillance in factory automation environments. Products include Watt-Hour Meters, Power-On Counters, Power-On Hour Meter, Air Flow Meters, Communication Devices and Data Collection Units.
-
product
Energy & Process Monitor
Real time monitoring and reportingComposite system with EMS and PEMSDesired reports like, Doff wise, shift wise, count wise, production, energy, UKGSpeed Vs Kw curve, trends, bar graphs, comparisonsAlerts on higher UKG, lesser production, utilization & power fluctuations.Maintenance alerts based on run hours production cost analysis - Cost Audits - Energy Audits
-
product
CBRN Detectors
RIID
A Radioisotope Identification Device (RIID) is a small, lightweight, portable instrument that identifies radioactive materials by measuring the energy of gamma rays they emit. RIIDs can also perform spectroscopic analysis to distinguish between different radioactive isotopes.
-
product
Laser Measurement Instruments
Wide-ranging line of laser power and energy measurement products that deliver accurate, ISO/IEC 17025 certified measurements, and laser beam diagnostics systems that measure spatial intensity distribution and beam size. All backed by more than 50 years of industry experience, with worldwide service and support.
-
product
Handheld Performance Tuner
Max Energy
Max Energy Tuning extracts every bit of energy possible out of every molecule of fuel giving you more miles at part-throttle and more power at wide-open throttle. In order to increase engine efficiency, horsepower and torque, our engineers first optimize the spark and fuel curves point by point over the entire rpm band. With the additional power and optimized transmission functions, drivers use less fuel to accelerate and maintain cruising speeds without the torque converter un-locking and transmission down-shifting to a lower gear. The results are maximum power and fuel mileage.
-
product
PXI/PXIe Battery Simulator Module, 6-Channel With V/I Readback
41-752A-011
Targeting EV, automotive, aerospace, energy storage and electric aircraft applications, the new battery simulator modules occupy a single PXI slot. These 6-channel battery simulators are capable of supplying up to 7 V and 300 mA per channel. The channels are fully isolated from ground and from each other, allowing series connection to simulate batteries in a stacked architecture.
-
product
Anemometers
Bristol Industrial & Research Associates Ltd
Biral provides a wide range of anemometers ensuring that we have a solution to almost every environmental wind measurement requirement. Our traditional cup and vane anemometers range from simple devices for general wind monitoring through to certified products for use in wind energy applications. Our ultrasonic anemometers, which benefit from having no moving parts, provide for everything from simple 2-axis measurement through to research quality 3-axis sensing and integrated turbulence measurement.
